The Cuppa Calculus: Why 12V Boiling Is a Bad Bargain on Most British Boats
Photo: 12V kettle and boat battery galley electrical setup, via i.pinimg.com
There is a special kind of optimism in the phrase 12V kettle. It suggests a world where a cigarette lighter socket, a thin red wire and a plastic jug can replace the galley stove. That world does not exist on most British boats. The physics is against you, the wiring is against you and the second cup is definitely against you.
I am not saying it is impossible. I am saying it is usually a bad bargain. If you want a quick cuppa while the engine is running, fine. If you want a galley routine, look elsewhere.
The basic physics of a brew
Boiling water takes energy. To raise a litre of water from roughly 20C to 100C takes about 0.1 kilowatt-hours, before you account for losses. In 12V terms, that is roughly 8 amp-hours of energy in a perfect world. The world is not perfect.
A 12V kettle that draws 120W from a cigarette socket will take about an hour to boil a litre in theory, and longer in practice. That is not a kettle. That is a slow water heater with a handle. A 12V kettle that claims to boil faster is either drawing more current than the plug can safely supply, or it is being economical with the truth.
The cigarette-lighter kettle
Most cigarette-lighter kettles are low-power devices. They are designed for truck cabs, campervans and people with heroic patience. On a boat, the socket is often rated at 10A or 15A, the wiring is long and the voltage drop is real. A 120W load is about 10A at 12V. That is already close to the limit of some sockets, especially after a few seasons of damp and tarnish.
If you use one, use it with the engine running and keep an eye on the plug. If the plug is warm, the socket is warm or the voltage is sagging, stop. Do not hard-wire a cheap kettle to a random circuit because you are in a hurry. Fuses and cable ratings exist for a reason.
The inverter kettle
A proper 240V kettle through an inverter is faster, but it is not free. A 1kW kettle draws around 90A at 12V before inverter losses. That means thick cables, a serious fuse and a battery bank that can take the hit. It also means the alternator has to put the energy back.
On a small boat with a 100Ah lead-acid battery, boiling a litre this way is not a disaster once. Do it every morning and you are cycling the battery hard for tea. Lead-acid batteries do not enjoy deep discharges, and their usable capacity is less than the label suggests. Lithium banks cope better, but they still need charging.
What it does to batteries and engine hours
This is the bit the advert leaves out. Every amp-hour you take out has to go back in, plus charging losses. If you are running the engine just to make tea, you are burning diesel to heat water through a series of inefficient conversions. A gas ring does the same job directly.
If you already run the engine for charging, the kettle is a small extra load. If you do not, the kettle becomes the reason you run the engine. That is an expensive cup of tea.
Better ways to boil water
Gas is the obvious answer on most boats. A proper marine gas installation, a kettle with a lid and a bit of ventilation will boil a litre far faster than any 12V gadget. It also keeps the electrical system out of the equation.
Diesel and meths have their place. A diesel-fired hob or heater is not for everyone, but it works. A meths stove is slow but simple and well suited to small boats and canal craft. A good thermos is underrated. Boil once on the stove, fill the flask and stop reheating the same water all day.
Low-draw 12V kit has its uses, but be honest about them. A 12V mug is fine for keeping a drink warm or heating a small amount of water when the engine is running. It is not a galley strategy.
When 12V is not mad
There are boats where an electric kettle makes sense. A canal boat with a large lithium bank, a big alternator and shoreline charging can run a 240V kettle without drama. A boat with a generator can do it too. The key is that the infrastructure is already there. You are not asking a cigarette socket to do a job it was never designed for.
For everyone else, the sensible routine is simple. Use gas for boiling. Use a thermos for keeping. Use the 12V socket for charging phones and running a small pump, not for making a full round of teas.
The 12V kettle is not evil. It is just a very optimistic solution to a problem that a stove solves better.